64000 Nm Special TCVJ(R) Alignment Eliminator
(Product Code: 64C-5)
Description:
True constant velocity high angle shaft coupling through all angles and rotation and articulation
Maximum working articulation angle of 5 degrees. Coupling does provide a stroke limiting device to prevent angle being exceeded.
Nominal torque rating of 64,000Nm at full articulation angle based on bearing life L10 specifications. (1)
Maximum peak torque rating of 130,000 Nm for short duration periods.
Maximum speed of rotation 300 rpm.
Generation and excitation of vibration forces is minimised through patented spherical dividing mechanism providing true constant velocity rotation.
True point centricity enabling pivoting applications to be fully realised
High torsional and radial rigidity .Axial length compensation can be achieved by appropriate splined shaft connections or similar if required.
High axial rigidity feature allows for axial load transfer. eg transfer of thrust loads.
Combine two TCVJ couplings with a splined connecting shaft to provide axial and radial misalignment applications up to 5 degree angles.
No requirement for phased or parallel connecting flanges as with traditional UJ technology.
Minimal heat generation from roller bearing componentry unlike traditional cv joint technology thus providing highest efficiency and maximum service life at high speeds AND full angle.
(1)Actual bearing life depends on combination of factors including equivalent speed, torque and angle as well as shock loads, relubrication frequency and environmental conditions.
Special Instructions:
Not a stock item
Product can run submerged in water
Note: Continuous collinear operation of the TCVJ coupling at 0 degrees is not recommended as this will cause excessive wear on bearings and cause damage to the coupling. For maximum efficiency and life of the TCVJ coupling, a minimum operating angle of 0.5 degrees is recommended.
Manufacturer: Thompson Couplings Limited
Unit Of Measure: EA
Price On Application
